Keyence GT-A22L Manuel d'utilisateur télécharger pdf

GT Series - Digital Contact Sensors

Sensor Head (Air Push Models)

Supplemental Manual

Read this manual before using.

After reading this manual, keep it in a safe place for quick reference.

Safety Precautions

Cylinder

•

This product uses a single-acting cylinder. The internal spring will

return the cylinder to its home position when air pressure is

removed. DO NOT supply air to the exhaust valve.

•

The cylinder is an integral part of the sensor. It cannot be removed.

Air

•

To ensure repeatable results, maintain regulated pressure to the air

cylinder.

•

Use of air cylinders, mist separators, dryers will ensure maximum

operating life.

Duct Assembly

•

The coupling socket and exhaust valve are integrated into the

sensor housing. They cannot be removed.

Names of Sensor Head Parts

Air Tube

The following tubing is recommended for all GT air push models:

How to Attach/Detach the Air Tube

Attaching the air tube

Feed the tubing into the socket until it bottoms out (about 1/2").

The socket will ensure a tight seal around the tubing.

•For best results, cut the end of the tube at a right

angle, ensure that the outer perimeter is not

damaged, and that it still maintains a circular cross

section.

•If the tube is not properly inserted, air leakage may

result (see figure below).

•After attachment, pull on the tube to make sure it is

secure.

Detaching the air tube

To detach the air tube, (1) press down on the release ring, (2) pull

out the tube.

•Before detaching the tube, be sure to stop any air

flow.

•Press down on the release ring evenly from both

sides, and pull the tube out. Uneven pressure may

result in damage to the tube or damage to the

operation of the air cylinder.

CAUTION

Connect this product to the GT-70A Series

sensor amplifier before using. Be sure to

carefully read the instruction manual supplied

with the sensor amplifier and that it is fully

understood before using.

Dust boot

Spindle

Contact

Coupling socket

Operation indicator

Exhaust valve

Mounting fixture

Dust boot*

Contact

Air cylinder

Connector

* Not mounted on GT-A10L/A22L.

Item Description

Recommended tubing material Nylon, Urethane

Tubing size

Outer diameter 4 mm

Inner diameter 2.5 mm

Coupling socket

Air tube

Note

Tube end

(2)

(1)

Release ring

Note

96M1757

1 2

Résumé du contenu

Page 1 - Sensor Head (Air Push Models)

1GT Series - Digital Contact SensorsSensor Head (Air Push Models)Supplemental ManualRead this manual before using.After reading this manual, keep it i

Page 2 - Specifications

2IP67 Enclosure RatingTo m a i n t a i n an IP67 enclosure rating for GT-A10/A22, the following must be satisfied:•Firmly connect tubing with 2.5 mm

Modèles reliés GT-A22 | GT-A10L | GT-A10 |

Commentaires sur ces manuels

Pas de commentaire

Keyence GT-A22L Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Keyence GT-A22L. KEYENCE GT-A22L User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés GT-A22 | GT-A10L | GT-A10 |

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Keyence GT-A22L