Keyence TM-3000 Series Manuel d'utilisateur télécharger pdf (Page 5)

Select OUT2 on screen 2 and make the setting for measuring (2) the step height.

Sliding the [PROG/RUN] switch on the side of the console switches from the setting screen to the

measurement screen.

The measurement results for (1) Diameter and (2) Step Height are displayed.

To set scaling or tolerance for measurement values, see page11 in this manual.

Select “OUT2” on screen 2 on the previous page.

Select “Step Height” for “Measurement type” on screen 4.

Select “Area 1/Area 2” on screen 4 and set the area as

shown on screen 4.

For area operation, see page 8 in this manual.

Press the [ESCAPE] key on the console to return to screen 1.

The step height measurement setting (2) is complete.

* To measure correcting the tilt, see the position correction function (page 8 in this manual).

Pressing the [SCREEN] key

switches the screen according

to each setting.

Screen 4

III

Manual P5-48

Step height measurement

XXX

Measuring the step height of a target

Setting procedure

Checking the measurement status

[SCREEN]

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Keyence TM-3000 Series Manuel d'utilisateur Page 5