Keyence DL-RS1A/IG Manuel d'utilisateur télécharger pdf (Page 6)

Connecting the Unit to Sensor Amplifiers

You use DL-RS1A by connecting it to sensor amplifiers. The connection method varies according to

the mounting type of the sensor amplifiers.

Before connecting DL-RS1A, you must install the main unit and expansion units of the sensor

amplifiers. For information on installing the sensor amplifiers, refer to the user's manual supplied with

the sensor amplifiers.

 Available sensor amplifiers

*1 The IG Series can be used only with the GT-70A Series and the GT2 Series.

When using together with those models, the maximum connectable number is 6. When using

with the IG Series, the maximum number is 4.

To use with 7 or more units, contact your nearest KEYENCE sales office.

Make sure that the sensor amplifiers are turned off before connecting the RS-

232C communication unit DL-RS1A to them. Connecting the unit while the sensor

amplifiers are turned on may damage the unit.

Name Type of amplifier Main unit

Expansion unit

Max. connectable number

Multi-Purpose CCD

Laser Micrometer

IG Series

DIN-rail mount IG-1000 IG-1050

4 units

(Main: 1, Expansion: 3)

Panel mount IG-1500 IG-1550

4 units

(Main: 1, Expansion: 3)

NOTICE

Connecting the Unit to Sensor Amplifiers

 Connecting the DL-RS1A to DIN rail mount sensor amplifiers

Remove the expansion protective cover from the sensor amplifier that you want to connect to the DL-RS1A.

Mount the DL-RS1A on the DIN rail and connect it to the sensor amplifier.

Make sure there is no space between the unit and the sensor amplifier.

Mount the end units (OP-26751, two units included) on either side of the sensor amplifier and DL-RS1A unit and

tighten the two screws on the top of each end unit.

(You can mount the end units in the same way you mount DL-RS1A.)

Sensor amplifier

Expansion protective cover

Sensor amplifier

DL-RS1A

Connector

Check that the sensor amplifier connector (for DIN

rail mounting) located on the side of DL-RS1A is not

installed at an angle as shown in the illustration to

the right. Connecting the unit with its connector

installed at an angle to a sensor amplifier may

damage the unit.

NOTICE

Sensor amplifier connector

RS-232C communication unit DL-RS1A

End unit

Make sure you firmly insert DL-RS1A all the way into the sensor amplifier. Turning

the power on when the unit is not inserted straight or firmly connected may

damage the unit.

NOTICE

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Keyence DL-RS1A/IG Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Keyence DL-RS1A/IG