Keyence FS-N10 Series Manuel d'utilisateur télécharger pdf (Page 33)

3-3 Adjusting Sensitivity

Basic Operation

3-11

- Digital Fiber Sensor FS-N10 Series User's Manual -

Two-point calibration is the most basic method of sensitivity setting.

The setting value can be established by simply pressing the [SET] button once each

when a workpiece is present. and when it is absent.

Press the [SET] button once

when no workpiece is pres-

ent.

Press the [SET] button once

when a workpiece is present.

Calibration is complete after

the setting value flashes

momentarily, and then stops

(lights up).

Press the button to adjust

the setting value.

Step 1 or step 2 may be performed first.

When performing two-point calibration on channel 2 of the 2-output type,

set the channel switch to " ".

Two-point Calibration

Workpiece

Reference

* If the difference between the 2 conditions is too small, "- - - -" flashes

after calibration is complete.

However, the setting value will still established.

Setting

value

Time

The setting value is set to the middle

of the values at which the [SET] button

was pressed first and pressed second.

Received

ht intensity

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 115 116

Pas de commentaire

Keyence FS-N10 Series Manuel d'utilisateur Page 33