Keyence IV Series Manuel d'utilisateur télécharger pdf (Page 26)

3-4

- IV Series User’s Manual (Field Network) -

Cyclic communication setting method

When setting by IV-Navigator (IV-H1)

Set the eld network settings of the sensor to

[EtherNet/IP].

Display the Advanced Sensor Settings

screen.

Select the [Environmental] tab, and then

click the [Setting] button under [Field

network].

Select [EtherNet/IP] in [Protocol] for the

eld network.

To enable the handshake control, check this

check box .



When the protocol is set as [Disable],

this setting item is shaded and cannot be

selected.



When the data handshake control is set as

[Enabled], the status result will not be updated

until [Result acquisition complete notice]

(“Address2, Bit0” Output Assembly) is input.

“Operating procedure of the cyclic

communication” (Page 3-26)

After the setting is completed, click the

[OK] button.

The system returns to the main screen in

[Program].

Click the [OK] button.

Cyclic communication

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 109 110

Pas de commentaire

Keyence IV Series Manuel d'utilisateur Page 26