Keyence DL-PD1 Manuel d'utilisateur télécharger pdf (Page 16)

2-2

- PROFIBUS DP Compatible Network Unit DL-PD1 User's Manual (IG) -

Connection and Configuration

2-1

Installation and Connection to a Sensor Amplifier

This section provides the procedures for installing the DL-PD1 and connecting to sensor

amplifiers.

The DL-PD1 can be connected with the sensor amplifiers which support D-bus. ("D-bus"

is the name of KEYENCE's wiring-saving system for sensor amplifiers.) How many

sensor amplifiers can be connected depends on the sensor amplifiers to be connected.

For specific numbers of connections, refer to the manual of each sensor amplifier.

Installation and Connection to Sensor Amplifiers

Point

Turn off the power before connecting the DL-PD1 and sensor amplifier.

1 Align the claw on the bottom of the DL-PD1 with the DIN rail. While pushing

the amplifier in the direction of arrow (1), press down in the direction of arrow

(2).

Reference

To remove the DL-PD1, raise the amplifier in the direction of arrow (3) while

pushing the amplifier in the direction of arrow (1).

2 Repeat step 1 to install additional sensor amplifiers or input units on the DIN

rail and connect them to the DL-PD1.

If the sensor amplifier connector has an expansion protective cover, remove the

cover before connecting the amplifier.

(1)

(3)

(2)

DL-PD1

Sensor amplifier

Expansion connector

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 73 74

Pas de commentaire

Keyence DL-PD1 Manuel d'utilisateur Page 16