Keyence DL-PD1 Manuel d'utilisateur télécharger pdf (Page 17)

2-1 Installation and Connection to a Sensor Amplifier

2-3

- PROFIBUS DP Compatible Network Unit DL-PD1 User's Manual (IG) -

Connection and Configuration

3 Mount the end units (OP-26751: a two-unit set shipped with the DL-PD1) on

both sides of the DL-PD1 and the sensor amplifier. Then, fix the end units

with the screws on the top of each end unit. (Tightening torque: 0.6 N•m or

less)

Mount the end units in the same way as the DL-PD1.

Make sure that the sensor amplifier connector (for DIN rail mounting

type) is not askew on the side face of the DL-PD1, as shown below. If

the connector is askew, the DL-PD1 may become damaged when

connected to the sensor amplifier.

Press the DL-PD1 into full engagement with the sensor amplifier. If

the DL-PD1 is not correctly connected, it may be damaged when the

power is turned on.

NOTICE

Sensor amplifier connector

DL-PD1

End unit

NOTICE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 73 74

Pas de commentaire

Keyence DL-PD1 Manuel d'utilisateur Page 17